Came Ver U4480-B Kit Manuel d'utilisateur télécharger pdf (Page 2)

The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.

ENGLISH

4.1 Automation

4 Description

2.1 Intended use

1 Legend

This symbol indicates sections to be read with particular care.

This symbol indicates sections concernig safety.

This symbol indicates notes to communicate to users.

This product complies with the following standards: EN 12978, UNI EN 954-1, CEI EN 60335-1, UNI EN 12453.

2 Destination and limits of use

The V900E automated kit is designed to power sectional and overhead doors installed in condominiums and residential homes.

The use of this product for purposes other than as described above and installation executed in a manner other than

as instructed in this technical manual are prohibited.

3 Reference standards

“IMPORTANT SAFETY INSTRUCTIONS FOR INSTALLATION”

“CAUTION: IMPROPER INSTALLATION MAY CAUSE SERIOUS DAMAGE, FOLLOW ALL INSTALLATION INSTRUCTIONS CAREFULLY”

“THIS MANUAL IS ONLY FOR PROFESSIONAL INSTALLERS OR QUALIFIED PERSONS”

2.2 Limits to use

24V (d.c.) gearmotor with lifting force of up to 500N for:

- counterweighted overhead doors up to 2.40m in height;

- spring-balanced overhead doors up to 3.25m in height;

- sectional doors up to 3.20m in height.

V900E was designed and manufactured by CAME CANCELLI AUTOMATICI S.p.A. and is compliant with the safety regulations

in force. Guaranteed 24 months if not tampered with.

The automation is mainly made up of an engine block, a transmission rail – with either a belt or chain transmission system – and

a transmission arm. Inside the ABS container which features a window for the courtesy light, we ﬁ nd: the 24V gearmotor, the

control panel and the transformer.

The gearmotor is made up of an aluminium die cast casing, which houses a worm-screw and helical-crown gear irreversible

reduction system, lubricated by permanent ﬂ uid grease.

The transmission guide is made of cold-pressed galvanised sheeting. At the front end there is belt/chain tension device; fastened

to the other end is an ABS support to hold up the gear motor.

Inside the transmission guide runs the traction slide which includes the emergency release mechanism and the bracket for faste-

ning to the transmission arm.

The transmission arm is available in several sizes and shapes depending on the type of garage door.

4.2 Description of the parts

GEARMOTOR SECTION

1) Protective cover

2) Gearmotor

3) Transformer

4) ZL56 circuit board

5) Standard transmission arm

1 2 3 4 5 6 7 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

Came Ver U4480-B Kit Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Came Ver U4480-B Kit